Prevention

	The AVALANCHE BALL is small, lightweight and desigend to fit on virtually any backpack. It increases safety as well on a daypack as on a big pack for multiday-tours!
	There is a velcro strap on the top of the system bag. Use this to fasten the system bag to the haul strap on the top of your pack..
	The connecting belt of the system bag is used for additional fastening of the AVALANCHE BALL to the pack. Attach the system to the pack as vertically as possible.
	There are three loops on the bottom of the system bag, which can be additionally attached to the closures of the top pocket. Use the middle loop for top pockets with one closure - use the two outer loops for top pockets with two closures.
	After fixing the AVALANCHE BALL to the pack, fix the release mechanism on the left or right shoulder strap facing forwards in a position you find comfortable. Use the enclosed velcro strip to attach the release mechanism to the left or right shoulder strap of your pack. Place the red ripcord handle on the velcro strap. Place the waist belt of the system around your waist. Pass the end of the waitsbelt through the buckle in the opposite direction. Please note that the flexible cord must always be led along the outside of the pack waist belt and/or shoulder straps.

	A short tug on the ripcord releases the system or checkts its perfomrance anytime and immediately.
	The system bag opens and releases the AVALANCHE BALL.
	The systemis mechanical and functions without batteries or gas cartridges – it can be tested easily at any time without cost.
	With the AVALANCHE BALL, there are no longer "technical safety loopholes" – like low batteries or empty gas cartridges. The cord is attached directly to the body. Therefore, the balloon remains even connected to the user if the pack is lost in the avalanche..